This shows you the differences between two versions of the page.
adc [2016/02/01 19:33] jktuning |
adc [2019/02/13 14:27] (current) |
||
---|---|---|---|
Line 55: | Line 55: | ||
* Connect 1 wire from IAT sensor to the ADC (0-3) input pin that corresponds to the jumper you just soldered together. | * Connect 1 wire from IAT sensor to the ADC (0-3) input pin that corresponds to the jumper you just soldered together. | ||
* Connect remaining wire from IAT sensor to ADC Ground pin | * Connect remaining wire from IAT sensor to ADC Ground pin | ||
+ | |||
+ | To enable the sensor in the calibration go to SETUP -> Sensors -> IAT | ||
+ | |||
+ | **Also make sure you select the correct calibration for the sensor, you can do this by right clicking on the voltage vs temperature table and selecting the ADC input option.** | ||
+ | |||
+ | [[http://www.nismotronic.com/Help/TCSA_SETUP.html#iatsensor]] |