Sidebar
adc
This is an old revision of the document!
Wiring a switch to an ADC input.
- 2 prong switch (clutch switch/cruise switch or toggle)
- 1k ohm 1/8 watt resistor
- 1 fA Diode
The diode is required if the switch is already wired to a 12V source, such as the E-brake warning light switch. The 5V going to the 10k ohm resistor is from the 5V output in the breakout box.
Vdc0 = 5 volt output from the ADC box.
Wiring a wideband to an ADC input.
The ADC inputs can handle any 0-5 volt wideband output signal.
Find your wideband's 0-5 volt output wire and connect it directly to any of the ADC 0-3 inputs on the breakout board.
Then select the wideband in the drop down list and enable it in the software.
adc.1444962290.txt.gz · Last modified: 2019/02/13 14:26 (external edit)
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution 3.0 Unported
