This shows you the differences between two versions of the page.
sd [2014/02/21 20:24] jktuning [Calibration Setup] |
sd [2019/02/13 14:27] (current) |
||
---|---|---|---|
Line 32: | Line 32: | ||
Setting up a calibration to be used for Speed Density operation is a little different than the normal setup for a MAF calibration. | Setting up a calibration to be used for Speed Density operation is a little different than the normal setup for a MAF calibration. | ||
- | - Select your load source | + | - Select your load source\\ {{wiki:sa_load.jpg}} |
- | {{wiki:sa_load.jpg}} | + | - Select and Enable your MAP sensor\\ {{wiki:sa_map.jpg}} |
- | - Select and Enable your MAP sensor | + | - Select and Enable your IAT sensor\\ {{wiki:sa_iat.jpg}} |
- | {{wiki:sa_map.jpg}} | + | - **DISABLE THE MAF SENSOR**\\ {{wiki:sa_mafdisable.jpg"}} |
- | - Select and Enable your IAT sensor | + | - Setup overboost tables (**even if naturally aspirated**)\\ {{wiki:sa_overboost.jpg}} |
- | {{wiki:sa_iat.jpg}} | + | |
- | - **DISABLE THE MAF SENSOR** | + | |
- | {{wiki:sa_mafdisable.jpg"}} | + | |
- | - Setup overboost tables (**even if naturally aspirated**) | + | |
- | {{wiki:sa_overboost.jpg}} | + |