sd
Differences
This shows you the differences between two versions of the page.
|
sd [2014/02/21 20:13] jktuning |
sd [2019/02/13 14:27] (current) |
||
|---|---|---|---|
| Line 27: | Line 27: | ||
| NismoTronic offers two preset IAT calibration tables which are calibrated around the GM open element IAT sensor. If you are using the EGT temp input then you can use the table that is supplied in the start-up calibration. If you are using an ADC input then you should right click on the IAT calibration table and select the ADC setup from the preset. | NismoTronic offers two preset IAT calibration tables which are calibrated around the GM open element IAT sensor. If you are using the EGT temp input then you can use the table that is supplied in the start-up calibration. If you are using an ADC input then you should right click on the IAT calibration table and select the ADC setup from the preset. | ||
| + | |||
| + | ==== Calibration Setup ==== | ||
| + | |||
| + | Setting up a calibration to be used for Speed Density operation is a little different than the normal setup for a MAF calibration. | ||
| + | |||
| + | - Select your load source\\ {{wiki:sa_load.jpg}} | ||
| + | - Select and Enable your MAP sensor\\ {{wiki:sa_map.jpg}} | ||
| + | - Select and Enable your IAT sensor\\ {{wiki:sa_iat.jpg}} | ||
| + | - **DISABLE THE MAF SENSOR**\\ {{wiki:sa_mafdisable.jpg"}} | ||
| + | - Setup overboost tables (**even if naturally aspirated**)\\ {{wiki:sa_overboost.jpg}} | ||
sd.1393013639.txt.gz · Last modified: 2019/02/13 14:26 (external edit)
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution 3.0 Unported
