adc
Differences
This shows you the differences between two versions of the page.
|
adc [2016/02/01 19:32] jktuning [Wiring IAT sensor to ADC input] |
adc [2019/02/13 14:27] (current) |
||
|---|---|---|---|
| Line 11: | Line 11: | ||
| Bottom of ADC v2 board | Bottom of ADC v2 board | ||
| * 4 sets of solder pads in the bottom center of the board can be jumped for a 4.7k ohm pull up resistor for each ADC0-3 circuit. | * 4 sets of solder pads in the bottom center of the board can be jumped for a 4.7k ohm pull up resistor for each ADC0-3 circuit. | ||
| - | * Only use when needed (IAT installs are the most common use for this option. | + | * **Only use when needed (IAT installs are the most common use for this option)** |
| {{http://www.j-k-tuning.com/NismoTronic/ADCv2_jumper.jpg}} | {{http://www.j-k-tuning.com/NismoTronic/ADCv2_jumper.jpg}} | ||
| Line 55: | Line 55: | ||
| * Connect 1 wire from IAT sensor to the ADC (0-3) input pin that corresponds to the jumper you just soldered together. | * Connect 1 wire from IAT sensor to the ADC (0-3) input pin that corresponds to the jumper you just soldered together. | ||
| * Connect remaining wire from IAT sensor to ADC Ground pin | * Connect remaining wire from IAT sensor to ADC Ground pin | ||
| + | |||
| + | To enable the sensor in the calibration go to SETUP -> Sensors -> IAT | ||
| + | |||
| + | **Also make sure you select the correct calibration for the sensor, you can do this by right clicking on the voltage vs temperature table and selecting the ADC input option.** | ||
| + | |||
| + | [[http://www.nismotronic.com/Help/TCSA_SETUP.html#iatsensor]] | ||
adc.1454355137.txt.gz · Last modified: 2019/02/13 14:26 (external edit)
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution 3.0 Unported
