User Tools

Site Tools


adc

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

adc [2016/02/01 19:31]
jktuning
adc [2019/02/13 14:27] (current)
Line 11: Line 11:
 Bottom of ADC v2 board Bottom of ADC v2 board
   * 4 sets of solder pads in the bottom center of the board can be jumped for a 4.7k ohm pull up resistor for each ADC0-3 circuit. ​   * 4 sets of solder pads in the bottom center of the board can be jumped for a 4.7k ohm pull up resistor for each ADC0-3 circuit. ​
-  * Only use when needed (IAT installs are the most common use for this option.+  ​* **Only use when needed (IAT installs are the most common use for this option)**
 {{http://​www.j-k-tuning.com/​NismoTronic/​ADCv2_jumper.jpg}} {{http://​www.j-k-tuning.com/​NismoTronic/​ADCv2_jumper.jpg}}
  
Line 53: Line 53:
 {{http://​www.j-k-tuning.com/​NismoTronic/​ADC_IAT_JUMPER.JPG}} {{http://​www.j-k-tuning.com/​NismoTronic/​ADC_IAT_JUMPER.JPG}}
  
-  * Connect 1 wire from IAT to the ADC (0-3) input pin you decided on+  * Connect 1 wire from IAT sensor ​to the ADC (0-3) input pin that corresponds to the jumper ​you just soldered together
-  * Connect remaining wire to ADC Ground pin+  * Connect remaining wire from IAT sensor ​to ADC Ground pin 
 + 
 +To enable the sensor in the calibration go to SETUP -> Sensors -> IAT 
 + 
 +**Also make sure you select the correct calibration for the sensor, you can do this by right clicking on the voltage vs temperature table and selecting the ADC input option.** 
 + 
 +[[http://​www.nismotronic.com/​Help/​TCSA_SETUP.html#​iatsensor]]
adc.1454355090.txt.gz · Last modified: 2019/02/13 14:26 (external edit)