adc
Differences
This shows you the differences between two versions of the page.
|
adc [2016/02/01 19:12] jktuning |
adc [2019/02/13 14:27] (current) |
||
|---|---|---|---|
| Line 11: | Line 11: | ||
| Bottom of ADC v2 board | Bottom of ADC v2 board | ||
| * 4 sets of solder pads in the bottom center of the board can be jumped for a 4.7k ohm pull up resistor for each ADC0-3 circuit. | * 4 sets of solder pads in the bottom center of the board can be jumped for a 4.7k ohm pull up resistor for each ADC0-3 circuit. | ||
| - | * Only use when needed (IAT installs are the most common use for this option. | + | * **Only use when needed (IAT installs are the most common use for this option)** |
| {{http://www.j-k-tuning.com/NismoTronic/ADCv2_jumper.jpg}} | {{http://www.j-k-tuning.com/NismoTronic/ADCv2_jumper.jpg}} | ||
| Line 39: | Line 39: | ||
| ====== Wiring IAT sensor to ADC input ====== | ====== Wiring IAT sensor to ADC input ====== | ||
| + | |||
| + | The IAT sensor is a vital part of any speed density conversion so we tried to make it easier for you guys to install. | ||
| + | |||
| + | The IAT sensor has two wires (polarity does not matter) that need to be ran to the ADC box on most B13 SR20 and S13 KA24 setups. These the ECUs do not support the EGR Temp input like the SR20DET ECUs do. | ||
| + | |||
| + | * Wire ADC 12v input to ECU power source (pin 38) | ||
| + | * Wire ADC Ground input to ECU ground source (pin 39) | ||
| + | |||
| + | {{http://www.j-k-tuning.com/NismoTronic/OBD1.jpg}} | ||
| + | |||
| + | * Flip over ADC box and make sure to solder two solder pads together on the corresponding ADC input you would like to use for the IAT input. | ||
| + | |||
| + | {{http://www.j-k-tuning.com/NismoTronic/ADC_IAT_JUMPER.JPG}} | ||
| + | |||
| + | * Connect 1 wire from IAT sensor to the ADC (0-3) input pin that corresponds to the jumper you just soldered together. | ||
| + | * Connect remaining wire from IAT sensor to ADC Ground pin | ||
| + | |||
| + | To enable the sensor in the calibration go to SETUP -> Sensors -> IAT | ||
| + | |||
| + | **Also make sure you select the correct calibration for the sensor, you can do this by right clicking on the voltage vs temperature table and selecting the ADC input option.** | ||
| + | |||
| + | [[http://www.nismotronic.com/Help/TCSA_SETUP.html#iatsensor]] | ||
adc.1454353937.txt.gz · Last modified: 2019/02/13 14:26 (external edit)
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution 3.0 Unported
